=
For details of the operations, refer to
ing the equaliser curve automatically (Auto
EQ)
p
To manually adjust the equaliser curve, set
“
Auto EQ&TA
”
to
“
Off
”
.
1
Press the HOME button to display the
Top menu screen.
2
Touch the following keys in the follow-
ing order.
The
“
Audio
”
screen appears.
3
Touch [Auto EQ&TA] repeatedly until
the desired setting appears.
!
Off
(default):
Turns the Auto EQ&TA setting off.
!
On
:
Turns the Auto EQ&TA setting on.
Adjusting the equaliser curve
automatically (Auto EQ)
By measuring the vehicle
’
s acoustics, the
equaliser curve can be adjusted automatically
to suit the vehicle interior.
WARNING
A loud tone (noise) may be emitted from the
speakers when measuring the vehicle
’
s acous-
tics. Never perform Auto EQ measurement while
driving.
CAUTION
!
Thoroughly check the conditions before per-
forming Auto EQ, as the speakers may be da-
maged if this is performed under the following
conditions:
—
When the speakers are incorrectly con-
nected. (For example, when a rear speaker
is connected as a subwoofer output.)
—
When a speaker is connected to a power
amp delivering output higher than the
speaker
’
s maximum input power capabil-
ity.
!
If a microphone for acoustical measurement
(sold separately) is not placed in an appropri-
ate location, the measurement tone may be-
come loud and measurement may take a long
time, resulting in battery drainage. Be sure to
place the microphone in the specified loca-
tion.
Before operating the Auto EQ
function
!
Perform Auto EQ in as quiet a place as pos-
sible, with the vehicle engine and air condi-
tioning switched off. Also, cut power to car
phones or mobile phones in the vehicle, or
remove them from the vehicle before per-
forming Auto EQ. Sounds other than the
measurement tone (surrounding sounds,
engine sound, telephones ringing, etc.)
may prevent correct measurement of the
vehicle
’
s acoustics.
!
Be sure to perform Auto EQ using the mi-
crophone for acoustical measurement
(sold separately). Using another micro-
phone may prevent measurement, or result
in incorrect measurement of the vehicle
’
s
acoustics.
!
To perform Auto EQ, the front speakers
must be connected.
!
When this product is connected to a power
amp with input level control, Auto EQ may
be impossible if the power amp
’
s input
level is set below the standard level.
!
When this product is connected to a power
amp with an LPF (low pass filter), turn the
LPF off before performing Auto EQ. Also,
set the cut-off frequency for the built-in LPF
of an active subwoofer to the highest fre-
quency.
!
The distance has been calculated by a
computer to provide optimum delay to en-
sure accurate results. Do not change this
value.
—
The reflected sound within the vehicle is
strong and delays occur.
Engb
119
Chapter
21
Audio
adjustments
Audio adjustments
