Pioneer AVH-X7700BT, Installation Manual

Page: 8 / 52

8
Installation on the steering
column
1 Detach the microphone base from the micro-
phone clip by sliding the microphone base
while pressing the tab.
1
2
1
Tab
2
Microphone base
2 Mount the microphone on the steering column.
2
1
1 Double-sided tape
2
Clamps
Use separately sold clamps to secure the lead where neces-
sary inside the vehicle.
Keeping it away from the steering wheel.
182
53
1
3
4
2
1 Dashboard
2
Mounting sleeve
3 Side bracket
4
Screw (2 mm × 3 mm)
DIN Rear-mount
1 Determine the appropriate position where the
holes on the bracket and the side of the unit
match.
When installing in a shallow space, use the following screw
holes.
1
1
1 Use binding screws (4 mm × 3 mm) only.
2 Tighten two screws on each side.
Use any of binding screws (4 mm × 3 mm), binding screws (5
mm × 6 mm) or flush surface screws (5 mm × 6 mm), depend-
ing on the shape of screw holes in the bracket.
1
2
3
1
Screw
2
Dashboard or console
3
Factory radio mounting bracket
In some types of vehicles, discrepancy may occur between
the unit and the dashboard. If this happens, use the supplied
frame to fill the gap.
Removing the unit
Extend top and bottom of the trim ring outwards to remove the
trim ring. And then loosen the screws (2 mm × 3 mm) to remove
the mounting sleeve.
●
When reattaching the trim ring, push the trim ring onto the
unit until it clicks. (If the trim ring is attached upside down,
the trim ring will not fit properly.)
1
3
2
1 Mounting sleeve
2
Screw (2 mm × 3 mm)
3 Trim ring
Installing the microphone
● Install the microphone in a place where its direction and dis-
tance from the driver make it easiest to pick up the driver’s
voice.
●
Be sure to turn off (ACC OFF) the product before connecting
the microphone.
Mounting on the sun visor
1 Fit the microphone lead into the groove.
1
2
1 Microphone lead
2
Groove
2 Attach the microphone clip to the sun visor.
1
2
1
Microphone clip
2
Clamps
Use separately sold clamps to secure the lead where neces-
sary inside the vehicle.
Install the microphone on the sun visor when it is in the up
position. It cannot recognize the driver’s voice if the sun visor is
in the down position.
< CRD4828-A > < CRD4828-A >
Installation
8