Pioneer AVH-P8400BT, Owner'S Manual

Page: 65 / 120

Setting the FM tuning step
Normally, the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to
100 kHz. It may be preferable to set the tuning
step to 50 kHz when AF is on.
!
The tuning step remains at 50 kHz during
manual tuning.
1 Turn the unit off.
Refer to Basic operations on page 10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 46.
3 Touch FM Step on the system menu to
select the FM tuning step.
Touching FM Step will switch the FM tuning
step between 50 kHz and 100 kHz. The se-
lected FM tuning step will appear.
RDS setting
Limiting stations to regional
programming
When AF is used, the regional function limits
the selection of stations to those broadcasting
regional programs.
1 Turn the unit off.
Refer to Basic operations on page 10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 46.
3 Touch RDS Setup on the system menu.
4 Touch Regional on the menu to turn
the regional function on.
#
To turn the regional function off, touch
Regional again.
Selecting alternative frequencies
When the tuner cannot get a good reception,
the unit automatically searches for a different
station in the same network.
1 Turn the unit off.
Refer to Basic operations on page 10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 46.
3 Touch RDS Setup on the system menu.
4 Touch Alternative FREQ to turn AF on.
#
To turn AF off, touch
Alternative FREQ
again.
Note
Sound may be temporarily interrupted by another
program during an AF frequency search.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Turn the unit off.
Refer to Basic operations on page 10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 46.
3 Touch Auto PI on the system menu to
turn Auto PI Seek on.
#
To turn Auto PI Seek off, touch Auto PI again.
Switching sound muting/
attenuation
Sound from this system is automatically
muted or attenuated when a signal from
equipment with a mute function is received.
!
Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Display the system menu.
Refer to Introduction of menu operations on
page 46.
2 Touch Mute/ATT until the desired set-
ting appears.
Touch Mute/ATT until the desired setting ap-
pears in the display.
En
65
Section
13
Menu
operations
Menu operations