En
65
English
Espa
ñ
ol
Deutsch
F
ran
ç
ais
Italiano
Nederlands
13
Section
Initial Settings
Selecting the illumination color
This product is equipped with two illumination
colors, green and red.
You can select the desired illumination color.
1 Press
5
or
∞
to select
ILLUMINATION
from
the INIT MENU, and press
A.MENU
.
ILLUMINATION adjustment indications are
displayed.
2 Select the desired illumination color with
2
/
3
.
Pressing
2
/
3
will switch
ILLUMINATION
between
RED or GREEN
and that status will be
displayed (e.g.,
ILLUMINATION :GREEN
).
Setting the rear output and sub-
woofer controller
This product’s rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (
REAR SP:FULL
) or
subwoofer (
REAR SP:S.W
) connection. If you
switch rear output setting to the
REAR SP:S.W
,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (
REAR SP:FULL
).
When rear output are connected to full range
speakers (when
REAR SP:FULL
is selected), you
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass
filter, phase) built-in
S.W CTRL:INTERNAL
or
the auxiliary
S.W CTRL:EXTERNAL
.
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 61) or subwoofer output
(refer to page 61) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press
5
or
∞
to select
REAR SP
from the
INIT MENU, and press
A.MENU
.
REAR SP adjustment indications are displayed.
2 Change the rear output setting with
5
/
∞
.
Pressing
5
/
∞
will switch between
REAR SP
:FULL
(full-range speaker) and
REAR SP :S.W
(subwoofer) and that status will be displayed.
