Pioneer AVH-P4300DVD, Owner'S Manual

Page: 68 / 112

3 Turn the ignition switch to ON or ACC.
If the car
’
s air conditioner or heater is turned
on, turn it off. Noise from the fan in the air
conditioner or heater may prevent correct auto
EQ.
4 Display the system menu.
Refer to Introduction of menu operations on
page 56.
5 Touch Auto EQ Measurement to enter
auto EQ measurement mode.
6 Plug the microphone into the micro-
phone input jack on this unit.
(AVH-P4300DVD)
(AVH-P3300BT)
7 Touch Start to start auto EQ.
8 When the 10-second countdown starts,
get out of the car and close the door within
10 seconds.
A measurement tone (noise) is emitted from
the speakers, and auto EQ measurement be-
gins.
When auto EQ is completed,
Complete is dis-
played.
When the car
’
s interior acoustic characteris-
tics cannot be measured correctly, an error
message will be displayed. (Refer to
Under-
standing auto EQ error messages on page 92.)
#
It takes about nine minutes for auto EQ mea-
surement to be completed when all the speakers
are connected.
#
To stop auto EQ, touch
Stop
.
#
To cancel auto EQ measurement mode during
this procedure, touch the following touch panel
key.
Canceling auto EQ measurement
mode.
9 Store the microphone carefully in the
glove compartment or another safe place.
If the microphone is subjected to direct sun-
light for an extended period, high tempera-
tures may cause distortion, color change or
malfunction.
10 Press
h
(eject) to close the panel.
(AVH-P4300DVD only)
Note
(AVH-P4300DVD)
Do not press
h
(eject) to open or close the panel
when you are using the microphone.
<QRB3126-A/N>68
En
68
Section
15
Menu operations