Pioneer A-A9-J, Operating Instructions Manual

Page: 17 / 109

Additional information 06
17
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 6:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Problem Remedy
The power does not turn on. • Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the amplifier to shut off automatically.
• If you’re trying to switch on using the remote control, make sure the
front panel
POWER button is switched on first.
• If the power shuts off automatically, take the unit to your nearest
Pioneer authorized service center or your dealer for servicing.
No sound is output when a
function is selected. • Make sure the component is connected correctly (refer to Connecting
up on page 7).
• Press
MUTE
on the remote control to turn muting off.
Noise during playback of a
cassette deck. • Move the cassette deck further from your amplifier, until the noise
disappears.
Turntable seems noisy and
distorted, or low in volume. • Make sure the MM/MC switch on the rear of the amplifier (near the
PHONO input) is in the proper position for your turntable.
Can’t operate the remote
control. • Replace the battery (refer to page 6).
• Operate within 7 m, 30° of the remote sensor on the front panel (refer to
page 11).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off. • Press DIMMER on the remote repeatedly to return to the default.
A9_MY.book Page 17 Tuesday, October 10, 2006 10:40 AM