27
A-607R
8
REC SELECTOR switch /indicator(For TAPE 1/MD
terminals)
This switch is used to select the recording source component.
The signal from the selected component is output at the TAPE1/
MD jacks for recording. To select a recording source compo-
nent, press the REC SELECTOR switch so that the indicator of
the desired source component lights up. When this switch is set
to [TUNER] or [CD], the signal from the selected component
can be recorded regardless of the input selector switch and
TAPE2 MONITOR button settings.
CD
: To record from the equipment connected to the CD
terminals.
TUNER
: To record from the equipment connected to the
TUNER terminals.
SOURCE : To record from the equipment selected by the IN-
PUT SELECTOR knob.
OFF
: In this position, nothing from the REC terminals of
TAPE 1/MD is output. Set to this position when not
recording; the cassette deck will be disconnected,
improving sound quality.
NOTE:
The function selected using the INPUT SELECTOR knob will
be recorded irrespective of the position of the REC SELECTOR
switch (TAPE 2 MONITOR terminals).
9
BALANCE control
Should normally be left in the center position. Adjust the bal-
ance if the sound is louder from one of the speakers. If the right
side is louder, turn toward the L (left) position and if the left side
is louder, turn toward the R (right) position.
NOTE:
This control does not operate when the DIRECT button is in the
on position.
0
DIRECT button/indicator
Use this button when you do not wish to pass the output from
input terminal equipment through the various frequency adjust-
ing circuits (BASS, TREBLE, BALANCE, LOUDNESS).
On : The indicator lights. The signals input through the input
terminals are reproduced without passing through the
various frequency adjusting circuits. This results in flat,
pure sound which is a more faithful reproduction of the
input source.
Off : The indicator goes out. The signal passes through the
various frequency adjusting circuits.
-
LOUDNESS button/indicator
Use when listening at low volume level.
On : The indicator lights. Boosts low and high frequencies to
give added punch to playback even at low volume level.
Off : The indicator goes out. Should normally be left in this
position.
NOTE:
This button does not operate when the DIRECT button is in the
on position.
=
TREBLE tone control
Use to adjust the high-frequency tone. The center position is the
flat (normal) position. When turned to the right, the high-frequency
tone is emphasized; when turned to the left, the high-frequency
tone is de-emphasized.
NOTE:
This control does not operate when the DIRECT button is in the
on position.
~
BASS tone control
Use to adjust the low-frequency tone. The center position is the
flat (normal) position. When turned to the right, the low-frequency
tone is emphasized; when turned to the left, the low-frequency
tone is de-emphasized.
NOTE:
This control does not operate when the DIRECT button is in the
on position.
!
PHONES jack
When using headphones, insert the plug into this jack.
@
SPEAKERS B (ON/OFF) button/indicator
Use this button to listen to the speaker system connected to the
SPEAKERS B terminals.
On : The indicator lights. Sound is heard from the speaker
system.
Off : The indicator goes out. No sound is heard from the
speaker system. Set to this position when listening with
headphones.
#
SPEAKERS A (ON/OFF) button/indicator
Use this button to listen to the speaker system connected to the
SPEAKERS A terminals.
On : The indicator lights. Sound is heard from the speaker
system.
Off : The indicator goes out. No sound is heard from the
speaker system. Set to this position when listening with
headphones.
