4
REV-11 19, 12
Pop-up Drain Installation
Remove the pop-up stopper (E) and pop-up flange (F) from the pop-up
1.
assembly.
Apply adequate amount of plumbers putty underside of pop-up flange
2.
(F). Then insert pop-up drain assembly from underside of the sink and
secure the pop-up flange (F) from the top.
Rotate the drain body so that horizontal rod hole faces back of the fau-
3.
cet.Hold the pop-Up assembly in place and tighten the locknut (G).
Remove the excess putty. Connect the trap (H) ( check manufacturer’s
4.
instructions for installation).
Remove rod nut (I).
5.
Ensure the washers (K) is in place (for brass pop-up only). Insert rod (J).
6.
Tighten the rod nut (I).
Push rod down to open drain. Insert the pop-up stopper (E) carefully.
7.
Test if the pop-up stopper (E) is working properly.
Connect pop-up bracket to the rod using clip (L). Tighten the thumb-
8.
screw (M) to connect pop-up bracket to pop-up lift rod.