DAILY MAINTENANCE
4. DISASSEMBLING AND CLEANING THE SQUEEGEE
Check the squeegee is always clean, for better drying results.
T clean it you must:
o
1. Raise the squeegee body by turning the lever anticlockwise.
Check that the parking brake is engaged.
2.
.
egee.
.
s (2) on the squeegee connection to release the stud from its
.
ts seat.
6. Clean the inside of the squeegee and opening with water, remove any
impurities that prevent correct suction.
7. Carefully cl
8. Reassembl
3 Remove the suction tube (1) from the sque
4 Remove the pin
seat.
5 Pull the squeegee downwards until the right-hand stud is released from i
ean the squeegee rubbers.
e all the elements.
5.CLEANING THE CLEAN WATER FILTER
1. Turn the key of the master switch to the anticlockwise to the "OFF" position,
versions disconnect the plug from the
and remove the key, for the electric
mains socket.
2. Check that the parking brake is engaged.
3. Make sure that the solution tank is empty.
4. Unscrew the filter cap. (1)
5. Rinse the filter cartridge with running water.
6. Reassemble all the elements.
ATTENTION
: These operations must be carried out using gloves
to protect against contact with dangerous solutions.
2
1
1
2. DISASSEMBLING THE BRUSH
1. Turn the key of the master switch to the anticlockwise to the "OFF" position, and
remove the key, for the electric versions disconnect the plug from the mains
socket.
2
Check that the parking brake is engaged.
3. Raise the base, using the lever.
it comes out of the brush-holder plate
ase
h
n direction for single-brush bases is
5
r. You are advised to replace the
s than 15mm long.
.
4. With the base up, rotate the brush until
seat, as shown in the figure. The drawing shows the rotation direction to rele
t e brush of duel-brush bases, the rotatio
anticlockwise.
. Always check the bristles for signs of wea
brushes when the bristles are les
ATTENTION
: This operation must be carried out using gloves to
protect against contact with dangerous solutions.
25
