5
Insert the wires from the PINsub MS into the
hole in the small endcaps. Carefully twist the
small endcaps until finger tight.
Lightly pull on the wires to make sure they are
secure. If they come out of the Positap, try
again until they stay secure.
Using the 12 foot 3.5mm to 3.5mm supplied
subwoofer cable; plug one end into the green
female connector on the PINsub MS adapter.
Run the other end to the back of the pinball
machine.
Locate the vent hole in the right rear of the cabinet.
Push up on the vent screen to dislocate it to allow
the 3.5 mm cable to be fed down through the vent
hole.
Fish the 3.5mm subwoofer cable through the
vent hole in the bottom of the cabinet. Press up
on the screen just enough to allow the cable to
exit the system. Some screens may be difficult
to fish the wire through if they are made of
metal. You may need to loosen some bolts.
