NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
© 2014, Pinnacle Products International, Inc.
Indirect Fired Heater User’s Manual
®
Assembly Instructions
Model: PT-170T-IDF-EU
1. Insert axle through holes in wheel support.
2. Slide the spacer onto axle.
3. Slide wheel onto axle and hold in place with
the axle nuts. (See Figure 5).
4. Place heater on wheel support and line up
holes on the fuel tank lip.
NOTE: Use lock washers and flat washers as
shown in figure 6 to secure the wheel frame
and handle to the tank.
5. Insert (2) short screws (50 mm) through the
first two holes from the front in the tank lip
on both sides of the tank and tighten firmly.
Make certain all (4) screws are secure.
6. Attach rear handle with (2) long screws
(64 mm) and (2) nuts through the two holes in
the rear of the tank on both sides and tighten
firmly. Make certain all (4) screws are secure.
(See Figure 6)
7. Attach cord wraps to handle using (2) short
screws (38 mm) each.
Figure 5
Axle
Axle Nut
Washer
Spacer
Tire
Wheel Support Frame
7
Figure 6
