NEVER LEAVE A FAN UNATTENDED WHILE OPERATING OR WHILE CONNECTED TO A
POWER SOURCE
© 2017, Pinnacle Climate Technologies, Inc. HVF Air Circulator User’s Manual
6
20" SHOP FAN: 20S-DDF
Installation and Assembly
1. Remove Knob Screw and Wing Nut from top of Post.
2. Slide Connector Bracket onto top of post.
3. Line up holes on the Post and Connector Bracket.
4. Re-insert the Knob Screw through the Post and
Connector Bracket and tighten firmly with the Wing Nut.
5. Place the fan on level ground in a safe, desired position
then connect to an approved power source.
6. Set desired tripod stand height following “Tripod
Operation Instructions” below.
Tripod Operation Instructions
TRIPOD LEG OPERATION
1. Fold legs out and slide support bracket to center of leg.
2. To adjust leg height; rotate locking ring clockwise to
loosen.
NOTE: Keep a firm grip on the tripod while leg is
unlocked! The leg will collapse into itself unless
held tightly.
NOTE: Be certain to make all three legs the same
height. Setting legs to different heights will make
the fan unbalanced and COULD FALL OVER.
3. Slide leg extension to desired height.
4. Rotate locking ring counter-clockwise and tighten firmly.
Be sure the leg is secure before moving to next leg.
5. Repeat steps 2-4 for remaining legs.
TRIPOD CENTER POST OPERATION
1. To change the post height; rotate locking ring
counter-clockwise to unlock post.
NOTE: Be certain to keep a firm grip on post while
unlocked! The fan will slide down to its lowest
point if it is not held and slowly moved to desired
position.
2. Raise or lower post to desired position.
3. Rotate locking ring clockwise to lock post and tighten
firmly.
DO NOT MOVE
OR ADJUST
FAN WHILE
IN OPERATION. THIS CAN CAUSE
DAMAGE TO FAN AND INJURY TO THE
OPERATOR.
OPTIONAL CEILING MOUNT
1. Attach Ceiling Mounting Kit to 2x4" stud that is able to
support 50 lbs continuously using M6x40 mm screw.
(See Figure 3)
2. Be certain that the Safety Pin lines up with the groove
on the Frame. (See Figure 4)
3. Slide Connector Bracket onto Ceiling Mounting Post.
(See Figure 5)
4. Rotate the entire fan so the safety pin locks into place
and the holes on the Mounting Post line up with the
holes on the Connector Bracket. (See Figure 6)
5. Insert the Base Knob through the Mounting Post and
Connector Bracket and tighten firmly with the Wing Nut
(See Figure 6)
The installer MUST
be certain that the
support bracket is
mounted to a mini-
mum of a 2x4" stud, and that it is able to support
50 pounds continuously.
WARNING
WARNING
Figure 3:
Optional Ceiling Mount
Figure 6:
Optional Ceiling Mount
Figure 5:
Optional Ceiling Mount
Figure 4:
Optional Ceiling Mount
