Fixing the lock
1) Cut the fixing bolt length to suit the thickness of your door.
2) Place the neoprene seals between the front and back plate and install onto door.
3) Tighten the upper and lower fixings although be sure not to over tighten the fixing bolts as this may
cause distortion and lead to poor operation.
Please note:
Do not close the door until you are sure that the code works.
Fitting the spring loaded spindle
1) The split is loaded with a spring which ensures the split line is in line with the center line of the latch.
2) The spring can be used for doors with a thickness of 35 - 60mm.
3) The spring installed must be on the end that goes into the front plate.
Split line of latch
Front plate
Fitting the striker plate:
1) Position the striker plate on the door so that it lines up with the flat base of the latch bolt (not the plunger).
2) Mark the inner and outer edges of the striker plate with a pencil/marker then remove and cut a 1mm rebate so that the striker plate
fits flush with the surface of the door frame.
3) Drill or cut the recess for the latch bolt.
4) Fix the striker plate with one screw first. Test the lock to see if it works and is latching and locking correctly. If not proceed with any
necessary adjustments before securing completely.
Handy Hint
• If your door frame interferes with the lever it can be reversed by simply loosening the screw from the large hole in the back with a
screwdriver which will then loosen the handle and allow you to rotate it in the position that best suits your door. Please refer to diagram.
Please note:
Every time you wish to unlock your door you must start by pushing “C”.
Warranty conditions
Any claim under this warranty must be made within 3 years of the date of purchase of the product. To make a claim under this warranty, take the product (with proof of purchase) to any Bunnings store (for AUS customers see www.bunnings.
com.au and for NZ customers see www.bunnings.co.nz for store locations). Pinnacle Hardware bears reasonable, direct expenses of claiming under the warranty. You may submit details and proof of purchase to our support centre for
consideration. The warranty covers manufacturer defects in materials, workmanship and finish under normal use. This warranty is provided in addition to other rights and remedies you may have under law: Our goods come with guarantees that
cannot be excluded under the Australian consumer law or Consumer Guarantees Act 1993 (NZ). You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. This warranty excludes damage resulting from product misuse or product neglect, any modifications,
additions or alterations to the product including the addition of extra shelves. Additions or modifications can compromise the structure and safety of the product. The warranty covers domestic use only and does not apply to commercial
applications. This warranty is given by Pinnacle Hardware, ABN 87 614 496 196, 28 Hudson Court, Keysborough Vic 3173, 1800 349 776, Email: [email protected]. Products sold in New Zealand are imported by Bunnings New Zealand.
‘Pinnacle’ is a trademark. © Pinnacle Hardware. Suitable for model number 0187081 | DSS003.
Summary of Contents for IKONIC DSS003
Page 3: ...13mm Hole 13mm Hole...
