D
EKO
C
AST
Quick Install
5
4. Connect the Dongle
•
DekoCast requires and comes pre-installed with a supplied
hardware key, or “dongle", that connects to the system’s parallel
port (11). If the dongle is not connected already, connect it now to
the parallel port (11). If you cannot find the dongle, please contact
your customer service representative.
5. Connect the Power
•
Plug a chassis power cable into the socket on each of the two
power supply panels (1a and 1b) and into separate AC power
outlets. Ideally, each power supply should be connected to a
separate electrical circuit.
System voltage: 110/220V auto-sensing, 50/60 Hz
•
Plug the SVGA monitor power cable into an AC power outlet.
Make sure that any other peripheral equipment is correctly
connected to a power source.
6. Power Up and Log On
•
Turn on the power switch on each power supply panel (1a and 1b).
The LED under each switch lights yellow to indicate that the
system is on and in stand-by mode.
•
Press the power switch on the front of the chassis. The LED lights
green, the system boots up and prompts you to log on.
•
Log on to Windows 2000 as user “Deko” with blank password.
•
Double-click the DekoCast icon on your desktop to launch
DekoCast.
