NEVER LEAVE HEATER UNATTENDED WHILE CONNECTED TO A POWER SOURCE
© 2017, Pinnacle Climate Technologies, Inc.
Electric Garage Heater User’s Manual
Assembly Instructions
Tools Needed:
– Power Drill
– 4 mm or 5/32 in. drill bit
– Phillips head screwdriver
– Stud finder
Ceiling Mounting
1. Locate wood stud in ceiling where heater will be
mounted.
2. Use swivel bracket to mark 4 holes for drilling. Be
sure a minimum of 2 holes (across swivel bracket
from each other) will be drilled into wood stud in
ceiling.
3. Pre-drill 4 holes for screws.
4. Attach swivel bracket to ceiling using 4 washers
and screws (attach 2 screws to stud, then turn 90
degrees to attach 2 final screws.) Two (2) screws
must be attached to a wood ceiling joist (min
1.5”). If 2 remaining screws cannot be attached
to a wood ceiling joist, then moly / toggle bolts
should be used for remaining holes.
4
If you are
attaching this
heater to a ceiling
surface other than a wood ceiling joist
and drywall, please use appropriate
fasteners. The screws included with your
heater are not intended to be used for
metal joists.
HEATER MUST
BE ATTACHED
TO A JOIST WITH
A MINIMUM OF TWO (2) SCREWS IN
OPPOSING HOLES.
Be certain
adjustment knobs
are tightened
firmly to secure heater to swivel bracket.
WARNING
WARNING
WARNING
Attaching Heater to Swivel Bracket
1. Line up holes on swivel bracket with the holes on
the heater shell.
2. Attach heater to swivel bracket with adjustment
knobs larger 8 mm washers and locking washers.
(Page 5)
2
1
3