Pinion P-Line P1.12, Owner'S Manual

Page: 8 / 36

safety
8
Intended use
use other than as intended may cause accidents resulting in death
or serious injury.
pinion gearboxes are designed and intended exclusively
•
· for installation on bicycle frames designed for the purpose with stiff rear triangle
and a corresponding gearbox interface in the area of the bottom bracket.
•
· for installation on bicycle frames designed for the purpose with suspension rear
triangle and a corresponding gearbox interface in the area of the bottom bracket
– and, if necessary, in combination with a suitable chain or belt tensioner system
that compensates for the distance between the chain ring and sprocket or between
the belt sprockets that varies with the movement of the suspension.
•
· for use with a single-gear rear freewheel rear hub without a back pedal brake*.
•
· for use with a rear cassette freewheel rear hub with spacers for setting the correct
chain line.
•
· for use with a rear hub with an electric drive motor.
•
· for use with a suitable chain or belt tensioner system.
•
· for the maximum approved rider weight – see
teChnICal data
, page 6.
pinion gearboxes must never be used in combination with a stiff single gear rear hub!
basIC safety InstruCtIons …
always remember that cycling can be dangerous for the rider and other people and also
for the bicycle and its components. accidents resulting in death or serious injury may
happen even with the best protective equipment and all required safety devices.
use your common sense and avoid dangerous actions.
* a back pedal brake cannot be used with the freewheel integrated in the gearbox!