SAT-N Installation Guide
10
Parameter
Description
Handshake
frequency
Click and select the open ACK between the options
Inactive, LoHi, 1400 or
2300.
PSTN line check
Check to enable continuous phone line voltage test.
PGM/Tamper
Checked: the PGM input will be triggered by the control panel.
Unchecked: the PGM input will be triggered by case’s tamper switch.
Polarity
The PGM input polarity. Click and select between Normally Close and
Normally Open
Tamper report
code
Alarm code for case’s tamper switch. Default code: 137
SAT-N phone
number
4-digit number for triggering the SAT-N by a dial from alarm system
The GSM-200 parameters
The following table describes the parameters of the GSM-200.
Parameter
Description
GSM-200 is installed
Enable/Disable the GSM communicator
Set as the primary channel When selected the SAT-N will transmit via the GSM-200 before the
net4pro (where relevant)
Network APN, Username
and Password
Obtain this information from the mobile operator
Central Monitoring Station’s
IP/URL and Port
Obtain this information from the CMS
The net4pro parameters
The following table describes the parameters of the net4pro.
Parameter
Description
net4pro is installed
Enable/Disable the network card
Set as the primary channel When selected the SAT-N will transmit via the net4pro before the
GSM-200 (where relevant)
net4pro: supervision
interval (sec)
The interval time for transmitting a test event (790)
CMS’s URL/IP and Port
Obtain this information from the CMS
