Pima Hunter-Pro 8144, Installation Manual

Page: 21 / 116

HUNTER-PRO Series 21
Hunter-Pro Series & Captain 8 Installation Guide
3.2.9 I/O-WN
The I/O-WN is an integrated wireless module for adding wireless zones. See section ‎3.2.9 for
more details. It interfaces the system's BUS wires.
I/O-
WN
Control
Panel
1 -V -
2 +V +
3 OUT IN
4 IN OUT
Diagram 12. I/O-WN wiring
For further information on the I/O-WN, refer to its installation guide (P/N 4410208)
.
3.2.9.1 I/O-WN LEDs
LED Indication Status
RUN
(Green)
Operation and
voltage supply
Illuminating OK
Off Voltage supply fault
Flashing Card voltage fault
DATA
(Red)
Communication
Illuminating Communication fault; see the Fail LED
for information. Off
Flashing
OK
RX
(Red)
Reception
Illuminating No reception
Flashing Reception OK
VALID
(Green)
Registering the
module Off Signal has not been acquired
Flashing Signal has been acquired
FAIL
(Red)
The control
panel
1 blink pattern Valid frame is not received from the panel
2 blinks pattern ACK is not received from the panel
3 blinks pattern The expander is not programmed
4 blinks pattern General/Fatal error. Occurs when no
transmission is received for one minute
3.2.9.2 Wireless Faults Display
In “Fast display” mode
Wireless accessories faults. For example: zone #7 (tamper) is open, no supervision signal is
received from zone (detector) #14, low battery in zone #17.
4
1-V
2+V
3
I/O-WN
BUS
1 2 3 4
OUT
KEYPAD
IN
+ -
Control panel