Pima GSV512, Installation Instructions Manual

Page: 2 / 8

-2-
 Voice
o
Half Rate (HR)
o
Full Rate (FR)
o
Enhanced Full Rate (EFR)
o
Adaptive Multi-Rate (AMR)
o
X 2 (Embedded Class-AB amplifier in one channel)
o
PCM
o
Echo Arithmetic
 Echo Cancellation
 Echo Suppression

Noise Reduction
 Output power
o
Class 4 (2W @850/900MHz)
o
Class 1 (1W @1800/1900MHz)
 Sensitivity
o
GSM850: -109dBm
o
GSM900: -109dBm
o
DCS1800: -109dBm
o
PCS1900: -109dBm
 DATA Mode, GPRS (1Rx, 4Tx) CLASS 12
o
GSM850

@power level #5 <660mA, Typical 457mA
 @power level #12, typical 182mA
 @power level #19, typical 106mA
o
EGSM900
 @power level #5 <660mA, Typical 484mA
 @power level #12, typical 187mA
 @power level #19, typical 109mA
o
DCS1800
 @power level #0 <530mA, Typical 461mA
 @power level #7, typical 149mA
 @power level #15, typical 97mA
o
PCS1900
 @power level #0 <530mA, Typical 439mA
 @power level #7, typical 159mA
 @power level #15, typical 99mA
Content of the product package
 GSV512 Add-on  A Cable  This guide
How to install the GSV512
Disconnect the control panel from AC power and remove the batteries before installing the GSV512.
Follow the next steps to install the add-on.
1.
Make sure the
VISION
is located away from other transmitting devices, or near large metal objects.
2. Carefully pull out the SIM card tray (no. 3 in the above figure) from the socket, by gently pressing the eject bar (no. 7 in the figure).
3.
Align
(U)SIM1 (Main) card into slot 8, and (U)SIM2 (Backup) card into slot 9, with the metal contacts facing downwards and the
angled corner of the card positioned correctly, and carefully insert the tray into place.
4. Connect the antenna to its connector (no. 10 in the figure).
5. Connect the add-on’s circuit board connector (no. 12 in the figure) to its socket on the control panel’s circuit board.
6. Connect the control panel to power and insert the batteries. Observe polarity!
7. Use an LCD keypad (not supplied) and set the add-on; see how in the Installation guide.
8. Test the add-on using the Test and Diagnostics menu.
The LEDs
The GSV512 has four LEDs, described in the table below.
Label Color and state Description
LD1 Yellow blinks (64ms on/2000ms off) Modem is registered on the network
Yellow blinks (64ms on/800ms off) Modem is not registered on the network
Yellow blinks (64ms on/600ms off) Data transfer
LD2 Red Used by the manufacturer
LD3 Green solid Power on
LD4 Blue solid Used by the manufacturer
The buttons
Button Description
Pkey Used by the manufacturer
Reset Reset key: press to reset the modem after a firmware update
Ordering information
 GSV512 Kit: P/N 8300063