Pima GSM512, Installation Instructions Manual

Page: 2 / 8

-2-
o
DCS1800: -109dBm
o
PCS1900: -109dBm

DATA Mode, GPRS (1 Rx, 4Tx)
CLASS 12
o
GSM850
 @power level #5 <660mA,
Typical 457mA
 @power level #12, typical
182mA
 @power level #19, typical
106mA
o
EGSM900
 @power level #5 <660mA,
Typical 484mA
 @power level #12, typical
187mA
 @power level #19, typical
109mA
o
DCS1800
 @power level #0 <530mA,
Typical 461mA
 @power level #7, typical
149mA

@power level #15, typical
97mA
o
PCS1900
 @power level #0 <530mA,
Typical 439mA
 @power level #7, typical
159mA
 @power level #15, typical
99mA
Content of the product package
 GSM512 Add-on  A Cable  This guide
How to install the GSM512
Disconnect the control panel from AC and battery power before installing the GSM512.
Follow the next steps to install the add-on.
1.
Carefully pull out the (U)SIM card tray (no. 4+5 in the above figure) from the socket, by gently pressing the eject bar.
2.
Align
(U)SIM 1 (main) card into slot 4, and (U)SIM 2 (backup, if in use) card into slot 5, with the metal contacts facing downwards
and the angled corner of the card positioned correctly, and carefully insert the tray into place.
3. Connect the antenna to the antenna connector (no. 6 in the above figure), by rotating the SMA connector clockwise.
4. Connect the add-on’s circuit board connector (no. 11 in the above figure) to its socket on the control panel’s circuit board.
5. Connect the control panel to power.
6. Locate the antenna where the cellular signal is strong.
7. Set the add-on in the control panel.
8. Test the add-on.
The LEDs
The GSM512 has 4 LEDs, described in the table below.
Label Color and state Description
LD1
Yellow 1 blink/2000ms pause Modem is registered on the network
Yellow 1 blink/800ms pause
Modem is not registered on the network
Yellow 1 blink/600ms pause Data transfer
LD2 Red Used by the manufacturer
LD3 Green solid Power on
LD4 Blue solid Used by the manufacturer
The buttons
Button Description
Pkey
Used by the manufacturer
Reset Reset key: press to reset the modem after a firmware update
Ordering information
 GSM512 Kit: P/N 8300043