Installation and Operating Instructions
Date of issue: 05.07.2005 / Page 9 of 12
Document: 0800000423 / Version: 2 / 2518-05
Pilz GmbH & Co. KG, Sichere Automation, Felix-Wankel-Straße 2, D-73760 Ostfildern, Deutschland
Phone: +49 711 3409-0, Fax: +49 711 3409-133, E-Mail: [email protected], www.pilz.com
Template: 0850174292 Orig. 2
The safety switch shall not be used as mechanical
end stop!
Position of mechanical stop adjustable
(not supplied with safety switch)
Actuating forces (Extraction force):
Standard = 10 N
PSEN me3.02 = 30 N
PSEN me2.1, PSEN me3.01, PSEN me3.11,
PSEN me3.21 = 100 N
Mounting M20/M16 cable gland/cable:
Connection type:
2 or 4 screw connectors M3,5 or
6 screw connectors M3
Conductor cross section:
single core 0,5-1,5 mm²/litz wire with
connector sleeve 0,5-1,5 mm²
After mounting the gland
remove the piece inside
4 different directions of actuation by turning the cap
in position A or B:
1. remove
the
actuator
2. open
cover
lid
3. snap of cap
4. remove
cap
5. turn
cap
6. latch
cap
7. for fixing the cap close cover lid
Cover for
unused entry
Electrical connection
The electrical connection shall only be carried out by trained and qualified personnel!
The electrical contacts of the switches
PSEN me2
and
PSEN me2.1
feature 2 screw terminals M3,5.
Tightening torque M = 0,8 Nm.
The electrical contacts of the switches
PSEN me3, PSEN me3.01, PSEN me3.02, PSEN me3.1
and
PSEN me3.11
feature 4 screw terminals M3,5.
Tightening torque M = 0,8 Nm.
The electrical contacts of the switches
PSEN me3.2
and
PSEN me3.21
feature 6 screw terminals M3.
Tightening torque M = 0,6 Nm.
The connection requires a stranded wire with ferrule or a solid wire with a cross section of 0,5 – 1,5 mm².
For safety circuits acc. EN 60204 use the normally closed contact(s) (N.C.) only.
