Operation
Operating Manual PNOZ m ES ETH
1002700-EN-06
| 17
7
Operation
When the supply voltage is switched on, the PNOZmulti copies the configuration from the
chip card.
The safety system PNOZmulti is ready for operation when the "POWER" and "RUN" LEDs
on the base unit and the "POWER" LED on the PNOZ m ES ETH are lit continuously.
7.1
Messages
Legend
LED on
LED flashes
LED off
LED
LED status
Meaning
Power
No supply voltage
Green
Supply voltage is present
L/A 1 ( Link / Act 1 )
No network connection at X1 / No data traffic at X1
Green
Network connection present at X1 / Data traffic present
at X1
L/A 2 ( Link / Act 2 )
No network connection at X2 / No data traffic at X2
Green
Network connection present at X2 / Data traffic present
at X2
Fault
Red
Internal fault
Red
No connection to base unit
DHCP
Yellow
The unit could not be assigned an IP address by the
DHCP Server.
Yellow
The unit is waiting for the DHCP Server to assign an IP
address
7.2
Reset Ethernet connection settings
The Ethernet connection settings of the base unit can be configured in the PNOZmulti Con-
figurator.
You can reset the base unit's Ethernet connection settings to the default settings.
Proceed as follows:
}
Switch off the supply voltage
}
Remove the chip card
}
Restart the base unit without the chip card inserted.
The Ethernet connection settings are now reset to the default settings.
