Wing Servo/Flaps Assembly
The control horns are pre-installed at the factory, ready for use.
1.Take out the aileron / flaps plating from the wing.
With the wings upside down,
position the gear in inside
the wing on the mounting
brackets and mark the
location for the screws.
Double check the positioning
of your gear before drilling
any holes. Make sure that
the gear movement is free of
2.Use the supply L-shape
aluminium braket to install the servo.
Use 1.2 inch servo arm, install the
servo arm to the servo and mark the
drilling hole... Refer to pic below.
the gear movement is free of
any obstacles.
Please take care when
drilling not to drill through
the wood and out through
the composite shell of the
wing.