4. In the same screen, if you click the little ">" symbol on the right, while connected to the Pigtail
it should dig down into the network settings for the wireless network.
5. Is there an address in there? It will probably be 10.1.1.10. If not, press the back button and
wait about 10 seconds. Re-check for an address. It should assign itself one after a few seconds.
6. What is it and what is the subnet mask?
The address of the iPad should be 10.1.1.10 and the subnet mask should be 255.255.255.0.
The gateway will be set to 10.1.1.1.
7. Open HamLog. Click Tools->Pigtail. After about 10 seconds you should see an entry in the
Pigtail list, most likely it will be 10.1.1.1. If the Pigtail never shows up, something's wrong. I,
N3WG, have never seen this happen so we should chat. Get in touch via
[email protected].
8. Click your radio manufacturer, click your radio, click on the discovered Pigtail.
The text at the top of the screen should change to: Selected: 10.1.1.1 (Manufacturer)
9. Click the back button a couple times to get back to the main log screen. Click + to add a
contact.
10. The Pigtail should connect and a green icon should appear. If it fails to connect there will be
an informative message that pops up that says why.
13. If the freq and mode fields are not auto-populated, check the baud rate settings on your
radio. It should be 4800.
14. If the freq and mode fields are not auto-populated, reboot your radio. This issue has been
observed on certain Elecraft radios that need to be turned on after the Pigtail is connected.
15. If the freq and mode fields are not auto-populated and you're connecting to an
Icom
radio, is
the radio set to Ci-V address 58H?
16. If the freq and mode fields are not auto-populated and it's an
Icom
radio
and you're using
the CT-17 adapter from Pignology
, is the Pin 4 Power jumper installed?
17. If you get an error message about an issue with QRZ, this is because the device cannot talk
to the Internet while connected to the Pigtail.