7
www.pifco.co
Assembling the Tripod:
To use your tripod fan, start by assembling the
base.
1.
To assemble your tripod fan, start by
placing the tripod stand on a flat, even
surface.
2.
Pull each of the extendable legs out
from inside the main body of the tripod
and adjust them to the required height.
When the legs have been adjusted to
the required height, turn the height
adjustment locking nuts on each of the
three legs clockwise to tighten it and
secure each leg into position.
3.
The tripod is now ready for normal use.
Attaching the Fan Head to the
Tripod:
1.
Once the tripod base has been set up at
the required height, attach the fan head
to it to complete fan assembly.
2.
To attach the fan head to the tripod, first
remove the wing nut from inside the fan
holder base and set it to one side.
3.
Lower the fan head onto the tripod base
and thread the fan head screw through
the corresponding hole at the centre of
the base.
4.
Once the fan head is correctly positioned
on the tripod base, place the rubber
washer on the corresponding hole at the
bottom of the base and use a finger to
hold it in place so it does not move out of
position.
5.
With the washer held in place, thread
the wing nut through the washer and the
fan head screw and turn it clockwise to
tighten and secure the fan head to the
tripod base.
Using your appliance:
1.
Turn the speed selection dial to any
position other than ‘0’ to turn the fan on.
2.
Turn this dial to the ‘0’ position when the
fan is in operation to turn it off.
NOTE:
When the unit is powered down, the
fan blades will continue to spin for a few
seconds before finally coming to a halt.
Speed Selection:
1.
This fan is equipped with a choice of 3
speed settings: Low (1), Medium (2) or
High (3). Turn the speed selection dial to
the corresponding setting to select each
speed.
2.
Turn the speed selection dial to any of
the other two settings while the unit is
in operation to change wind speed. The
fan will automatically adjust to the new
setting within a few seconds.
3.
Turn the speed selection dial to the ‘0’
position while the fan is in operation to
turn the unit off. Wind will stop emitting
from the fan grille and the fan blades will
stop rotating after a few seconds to show
the unit has been turned off.
Adjusting the Air Flow:
This unit is equipped with a vertical tilt
function, which can be manually adjusted to
better direct the air flow.
1.
To adjust the vertical tilt angle of the fan,
firmly grip the fan head and push it gently
upwards or downwards as required.
Note:
Make sure that the fan is on a level
surface and away from any liquids.
