pico Technology PicoScope 2203, User Manual

Page: 14 / 22

PicoScope 2203, 2204, 2205 User's Guide 10
Copyright © 2008 Pico Technology Limited. All rights reserved. ps2203.en
3.4.2
Signal inputs
The PicoScope 2203, 2204 and 2205 PC Oscilloscopes have BNC oscilloscope
connectors. The inputs have an impedance of 1 M
W
, so they are compatible with all
standard scope probes including x10 attenuated types.
3.4.3
Signal Out connector
The SIGNAL OUT connector on the front panel carries the output of the oscilloscope's
built-in signal generator, which can generate a number of built-in waveforms as well
as arbitrary waveforms from a user-defined table of data.
Instructions for use
If you are using the PicoScope 6 program, refer to the PicoScope 6 User's Guide for
information on how to configure the signal generator.
If you are writing your own software, refer to the PicoScope 2000 Series
Programmer's Guide.
Signal generator output specifications
Refer to the Specifications table .
3.4.4
USB port
Connect the oscilloscope's USB port to your PC's USB 2.0 port using the USB cable
supplied. You can also connect it to a USB 1.1 port, but in this configuration the
oscilloscope will not operate at full performance.
11