Page 3.1
BRIC
INTEGRATED PXI MATRIX SYSTEM WITH BIRST™ (40-562B)
pickering
SECTION 3 - INSTALLATION
Page 3.1
REED RELAY MODULE 40-110/115/120/125
pickering
SECTION 3 - INSTALLATION
kg
PREOPERATION CHECKS (UNPACKING)
1. Check the module for transport damage and report any damage immediately to Pickering Interfaces.
Do not attempt to install the product if any damage is evident.
2. Position the chassis relative to any other equipment the module(s) will connect with. Ensure the chassis is not
connected to the electrical supply.
3. Ensure that the designated area for the chassis containing the module is of flat and solid construction to
withstand and support the combined weight of the module(s) and chassis.
SECTION 3 - INSTALLATION
Refer to the Warnings and Cautions at the front of this manual
Modular products require installation in a suitable PXI/LXI chassis. The module is designed for indoor use only.
Figure 3.1 - Installing the Module into a PXI/cPCI/LXI Chassis
PXI / LXI Chassis
Figure 3.1 - Installing the Module into a PXI / cPCI / LXI Chassis
PXI / LXI Chassis
BRIC Module
Ejector
Handle
in Down
Position
pic
ker
ing
BRIC
4
Injector/Ejector Rail
Figure 3.2 - Backplane Connectors on a BRIC12 Module
Page 3.1
REED RELAY MODULE 40-110/115/120/125
pickering
SECTION 3 - INSTALLATION
kg
PREOPERATION CHECKS (UNPACKING)
1. Check the module for transport damage and report any damage immediately to Pickering Interfaces.
Do not attempt to install the product if any damage is evident.
2. Position the chassis relative to any other equipment the module(s) will connect with. Ensure the chassis is not
connected to the electrical supply.
3. Ensure that the designated area for the chassis containing the module is of flat and solid construction to
withstand and support the combined weight of the module(s) and chassis.
SECTION 3 - INSTALLATION
Refer to the Warnings and Cautions at the front of this manual
Figure 3.1 - Installing the Module into a PXI/cPCI/LXI Chassis
PXI / LXI Chassis
BRIC Backplane
Connector
BRIC12 Backplane Connector
- Power Only (5th PXI Slot)
BRIC12 Backplane Connector
- Data & Power (1st PXI Slot)
Note: For BRIC12 Modules,
both connectors must
be mated to the chassis
backplane. The second
connector draws power
only (no PXI interface).