5
Installation:
The Messager MP3 should be installed using the following steps:
Step 1:
Wall or shelf mount the unit. Screws and rubber feet are supplied in the accessory kit.
Step 2:
If connecting to an amplifier make sure it is turned OFF for this part of the installation.
Step 3:
Connect a RCA cable (supplied in the accessory kit) to the OUTPUT jack on the rear of the unit. Depending
upon the required impedance use either the 8Ω or 600Ω output RCA jack. Connect the other side to the MOH port
on the phone system, PA system or speaker.
Step 4:
Insert the Message Mate cartridge. If insertion of the cartridge is difficult, turn it over and try reinserting.
The cartridge should slide into the slot smoothly. See Message Programming & Operation section if cartridge is
blank.
Step 5:
Attach the included power pack to a wall or power strip receptacle, then attach the other end to the jack on
the rear of the unit labeled 12VDC.
Step 6:
If any amplifiers were turned OFF during installation then turn then back ON now.
Step 7:
Adjust the volume level pot labeled VOLUME on the rear of the unit. Depending upon the application
either call into the phone system and be placed on hold OR listen to the PA systems speakers to fine tune volume.
Volume up is clockwise, volume down is counter-clockwise.
OR
To MOH port
or PA System
Wiring Diagram
Optional: Plug to
computer to program
Summary of Contents for Messager MP3
Page 1: ...Messager MP3 Installation User Manual...
Page 2: ......