-7-
PKI-0072-4
1
After installation, if the lamp does not activate
●
Check the wiring and make sure there are no faulty or irregular connections .
●
If the switch illumination does not light up.
●
Verify the (+) wire from the switch is properly connected. If it is not correctly connected it will not activate.
●
Verify the fuse located on the vehicle's wiring system. (The switch's (+) wire should be connected to the
fuse box). If it is burned out, connect it to another circuit.
●
If the switch itself is faulty, the same symptoms may exist. We recommend that the entire switch unit
be
replaced.
●
Check the fuse for the switch harness. If it is burned out, follow instructions indicated in
[ 3 Fuse replacement Procedures].
●
The switch illumination lights up but when operating does not work.
●
Check the connectors on the battery terminals
●
There may be cases where each terminal related to specifi c sections may be incorrectly connected.
Check for any lose or cut wires and also for dirt or grime.
●
Check the switch operation If an abnormality is found, replace it accordingly.
2
If the LED suddenly fails to light up …
●
Check the fuse located on the vehicle's wiring system. If it is burned out, replace accordingly.
●
Check the fuse for the switch harness. If it is burned out, follow instructions indicated in
[ 3 Fuse replacement Procedures].
●
There may be cases where each terminal related to specifi c sections may be incorrectly connected.
Check for any lose wires and also for dirt or grime.
●
Check the switch operation if an abnormality is found, replace it accordingly.
3 Fuse
replacement
procedures
●
A short circuit may have occurred. Check the wiring system. If any type of damage is
found replace accordingly. (Non-replacement may pose a potential danger) (Short circuits are mainly
caused when wires are caught in the assembly or when there is a gap in the sleeve connected to the
lamp
harness).
Troubleshooting……
Verify each section according to the following.
●
Do not use driving lights into
oncoming
traffi
c.
Driving lights should never be
the only forward light source.
Driving lights should only be
used with the headlamp high
beams.
1.5
DRIVING Light Aiming
Typically, driving lights are mounted above the front bumper about 30 inches(76cm) from the ground to provide extra high
beam illumination. Driving lights can be mounted below the bumper, although they will not be as eff ective because the
light will hit the ground sooner and reduce the range of the light.
Visual aim is made with the center of the beam hot spot 1.5 inches(4cm) below the lamp center at 25feet(7.6m) with the
lamp facing straight forward. (See below.)
