7
Startup / Operation
7.1
Starting and Operating the V-417.216211E1
Requirements
✓
You have read and understood the
general safety instructions (p. 7)
✓
For startup with a load or in a multi-axis system: You have installed the V-417.216211E1
✓
You have read and understood the user manual for the electronics used.
✓
If a digital controller is used: You have read and understood the manual for the PC
software used.
✓
The electronics and if required, the PC software, have been installed (see the user manual
for the electronics).
DANGER
Risk of electric shock if the protective earth conductor is not connected!
If the protective earth conductor is missing or not properly connected, risk of dangerous
touch voltages on the V-417.216211E1 in the event of malfunction or failure of the system. If
there are touch voltages, touching the V-417.216211E1 leads to serious injuries or death by
electric shock.
►
Connect the V-417.216211E1 to a protective earth conductor before startup.
►
Do not remove the protective earth conductor during operation.
►
If the protective earth conductor has to be removed temporarily (e.g., for modifications),
reconnect the V-417.216211E1 to the protective earth conductor before restarting.
CAUTION
Risk of crushing by moving parts!
Risk of minor injuries from crushing between the moving parts of the V-417.216211E1 or the
load and a fixed part or obstacle.
►
Use safeguards to protect limbs areas where they could be caught by moving parts.
►
Observe the safety distances in accordance with DIN EN ISO 13857 when installing
protective structures.
NOTICE
Operating voltage excessively high or incorrectly connected!
Operating voltages that are too high or incorrectly connected can cause damage to the
V-417.216211E1.
►
Pay attention to the
operating voltage range (p. 28)
, which is specified for the
V-417.216211E1.
►
Pay attention to correct
NOTICE
Damage due to the high acceleration!
High acceleration can cause considerable wear and damage the V-417.216211E1.
►
Stop motion immediately if a malfunction occurs.
►
Avoid collisions with objects in the workspace or the end of the travel range.
►
Approach the end of the travel range always at a low velocity.
7 STARTUP / OPERATION
V417M0003EN
‒
11/19/2018
20
M O T I O N | P O S I T I O N I N G
