5 Installation
20
Version: 1.2
MP106E
M-235 Linear Actuators
Figure 4: Changing the end piece, schematic
1
End piece (flat) with
(a) wrench flat
2
Non-turning pusher with
(b) wrench flat
3
Mounting shaft with
(b) thread (for clamp connection, M20)
(c) mounting nut
4
Sleeve
Changing the end piece
1. Attach the pusher: apply an AF 8 open-end wrench to the wrench flats of the
pusher.
2. Manually unscrew the end piece to be replaced from the pusher of the M-235.
If this is not successful, use a second AF 8 open-end wrench.
3. Screw the new tip by hand into the pusher of the M-235.
4. Remove the pusher from the open-end wrench.