4 Control elements
4.1 Status-LEDs
Green LED Off::
No data transmission
Green LED flashes:
Computer receives data from the PLC
Yellow LED Off:
No data transmission
Yellow LED flashes:
Computer sends data to the PLC
5 Implementing
Connect your module as described in the chapter " Hardware installation " to the PLC and to the
programming device or to your computer.
If you want to respond to a PLC via the module you have to comply the requirements as
descript in the chapter "system requirements" . In addition,please make sure that the
module is properly connected
5.1 Programming software to use with direct access
After you have adjusted and connected the PLC-VCOM or the programming adapter to the COM-
port on your computer, you will be able to connect with your programming software
to the PLC and work with it.
How you have to adjust your programming software is described in the following points:
5.1.1 PG2000 für S5 (V5.10)
1.Start the PG 2000 software by using the desktop link or by using the application entry in the start
menu.
Handbook PG-USB
Page 8 of 21
