Phytec phyCORE-LPC2292/94, Hardware Manual

Page: 16 / 144

phyCORE-LPC2292/94
4
©
PHYTEC Messtechnik GmbH 2006 L-658e_5
Precise specifications for the controller populating the board can be
found in the applicable controller User’s Manual or Data Sheet.
The
descriptions in this manual are based on the Philips LPC2292/94. No
description of compatible microcontroller derivative functions is
included, as such functions are not relevant for the basic functioning
of the phyCORE-LPC2292/94.
The phyCORE-LPC2292/94 offers the following features:
•
subminiature Single Board Computer (60 x 53 mm) achieved
through modern SMD technology
•
populated with the Philips LPC2292/94 microcontroller
(TQPF-144 packaging)
•
improved interference safety achieved through multi-layer PCB
technology and dedicated Ground pins
•
controller signals and ports extend to two 100-pin high-density
(0.635 mm) Molex connectors aligning two sides of the board,
enabling it to be plugged like a "big chip" into target application
•
32-bit, demultiplexed bus mode
•
max. 60 MHz clock frequency (ca. 50 ns instruction cycle, extern;
ca. 10 ns internal Flash)
•
1.5 Gbyte external address space
•
2 MByte (up to 16 MByte) on-board Flash
1
•
on-board Flash programming, no dedicated Flash programming
voltage required through use of 3.3 V Flash devices
•
1 MByte (up to 8 MByte) RAM on-board, max. 1 MByte at 0 wait
states
1
•
up to two CAN transceivers (Infineon TLE6250V33)
•
RS-232 transceiver for two serial interfaces
•
optional SMSC 91C111 Ethernet controller with EEPROM
•
2 kByte (up to 8 kByte) SPI-EEPROM
1
•
I
2
C Real-Time Clock with internal quartz (can be battery buffered)
•
up to two free microcontroller Chip Select signals (if optional
Ethernet controller is not populated)
1
: Please contact PHYTEC for more information about additional module configurations.