Now you should click the "
" button to check if all the information about the
Test
wireless was entered correctly.
If the test reports "Wireless Test Successful" you can remove the network cable
and the camera should work through wireless network after a short delay.
STEP3
Tips:
1. Please note that as long as the cable is still attached, the camera's System page
will show " No wireless connection" since you are still using the wired network
and only one network can be active.
After unplugging the Ethernet cable, system page shows "No Ethernet connection"
since the camera is connected to router with wireless connection.
2. This camera can be setup through a WPS connection if your router supports this
function. To connect to your camera to router through WPS, press the WPS
button on your router and then press the WPS button on the camera. This will
establish the connection. To learn how to set up the camera over Wi-Fi using WPS,
please read “
” on the
Setting up the Camera over Wi-Fi using WPS
Appendix G:
user manual which can be accessed at www.phylink.com.
33
