30
3 . I N S T A L L A T I O N
C o n n e c t i n g t o t h e I P P B X
Installing the Fiber Optic Cable
To connect the PoLRE switch to the uplink network switch or IP PBX using a fiber optic cable:
1.
Remove the black protective cap from the SFP transceiver module.
WARNING
:
DO NOT look into the SFP connector when it is installed in a Gbic port, as the
laser beam can cause serious eye injury.
2.
Connect your fiber optic cable to port
Gbic 1
or
Gbic 2
on the front panel of the PoLRE switch.
Note
: Both ports can be used. If only one connection will be installed, use the port labelled
GbE 1
.
