shutter release) and turn red when sending a signal or taking a photo.
When idle, the
Status LED will flash green once every 2 seconds.
2. The Status LED on the Strato TTL receiver will flash green once every 2 seconds
while the power is on and idle. The LED will turn red when a signal is received from
the transmitter and the connected flash or camera is fired.
3. When the battery level is
low
，
the Status LED on the receiver will flash red once every
0.5 seconds.
Channels
1. The Strato TTL System has 4 transmission channels: 1, 2, 3, 4.
2. Channels can be set on both the transmitter and receiver.
Setting Channels on the Transmitter
1. Press the Channel Selection Button on the transmitter
2. Each press of the button will cycle through channels 1, 2, 3, 4
3. Make sure the transmitter channel is the same as the receivers
4. Channels are visible on the transmitter LCD
Setting Channels on the Receiver
1. Move the Channel Selection Switch to settings 1, 2, 3, or 4
2. Make sure the receiver is set to the same channel as the transmitter.
Connecting
Strato TTL transmitter to the camera hot shoe
1. Turn off the camera and
Strato TTL transmitter
2. Slide the Strato TTL transmitter into the camera’s hot shoe mount.
3. Turn the Strato TTL locking ring until tight.
4. Turn on the Strato TTL transmitter.
5. Turn on the camera and set the shooting mode.
Connecting a flash to the Strato TTL receiver hot shoe
1. Turn off the flash and the Strato TTL Receiver.
2. Slide the flash into the receiver’s hot shoe mount.
3. Lock the flash with the flash’s locking mechanism.
4. Turn on the flash and the Strato TTL receiver.
5. Set the flash to ETTL mode.
Please Note:
It is not unusual for the flash to discharge once after turning on the Strato TTL.
Using the Strato TTL
to trigger flashes
1. Half-press the camera shutter button while the Strato TTL transmitter is connected to
the camera hot shoe and powered on. The AF assist light of flashes connected to
Strato TTL receivers on the same channel as the transmitter will illuminate. The
Status LEDs on the transmitter and receiver will turn green.
2. A full-press of the camera shutter button will fire flashes connected to Strato TTL
receivers on the same channel as the transmitter. Status LEDs on the Transmitter and
Receiver will turn red.
Please Note:
-Pressing the Shutter Button on the Strato TTL transmitter – flashes connected to
receivers on the same channel will not fire.
