Photon Focus MV8-D8424-G01-GT, User Manual, Page: 55 / 139

7
I/O Control
This chapter shows the structure of the physical input and physical output lines. It describes the
signal path and how to configure it.
The I/O control block contains a signal input path and a signal output path.
7.1 Input Signal Path
The camera has four physical signal input lines, which come from the input opto-isolator of the
camera hardware interface (see Section 13.6) and which are fed into the input signal path of
the camera. Fig. 7.1 shows the structure of the input signal path. The user can invert this signal
and its current status can be read by software.
I
n p u t S i g n a l P a t h L i n e 0
S t a t u s
I n v e r t
L i n e I n 0
I n p u t S i g n a l P a t h L i n e 1
I n p u t S i g n a l P a t h L i n e 2
I n p u t S i g n a l P a t h L i n e 3
L i n e I n 1
L i n e I n 2
L i n e I n 3
Figure 7.1: Input Signal Path
The output of the signal input path is distributed to following camera function:
• Acquisition Start Trigger
• Acquisition End Trigger
• Frame Start Trigger
• Frame Burst Start Trigger
• Frame Burst End Trigger
• Exposure Start Trigger
• Exposure End Trigger
• Counter Trigger
• Counter Event
• Counter Reset
• Encoder Reset
• Timer Trigger
• Line Out
• LED0 or LED1
MAN094 03/2021 V1.0 55 of 139