Phonic POWERPOD 750RW, User Manual

Page: 7 / 20

3
POWERPOD 750RW
English
9. Foot Switch Jack
This port is for the inclusion of a non-latching foot switch, used to
remotely adjust properties of the built-in Digital Effect processor.
The Powerpod 750RW features a single foot switch jack, which
allows the user to remotely turn on and off the digital effects.
10. EFX (Effect) Outputs
These 1/4" TS outputs are the final output from the EFX send
mixing bus. This feed may be used to connect to an external digital
effect processor, or even to an amplifier and speakers, depending
on your desired settings.
Rear Panel
11. Speaker Outputs
These jacks are used to connect to speakers, fed from the internal
power amp. On all models, they consist of 1/4" phone jacks. The
Amp Select switch determines the operation of these jacks. If the
Amp Select switch is set to "Main 1 / Main 2" or "Main / Moni", a
single speaker with a 4 to 8 ohm load can be connected to jack
A on both the Main 1 and Main 2 Speaker Outputs. You can also
connect two speakers with impedances between 8 and 16 ohms
to both jacks A and B of the Main 1 and Main 2 Speaker Outputs.
When using Bridge Mono mode, use the Speaker Output labeled
"Bridge" only to connect a Speaker with a loading between 8 and
16 ohms. Refer to the Speaker set up chart to the right for a more
detailed indication of how to connect speakers.
NB. Due to the fact that the signal has been processed by the power amp,
these ports should be used in conjunction with passive speakers only to
avoid damaging any other equipment.
9
10
11
SPEAKER SETUP
8Ω to 16Ω 8Ω to 16Ω 8Ω to 16Ω 8Ω to 16Ω
8Ω to 16Ω
4Ω to 8Ω 4Ω to 8Ω
NOT
USED
NOT
USED
NOT
USED
NOT
USED
One Speaker Per Channel
Two Speakers Per Channel
Bridge Mode
Using speakers with an incorrect loading can not only cause
distortion, but also irreversible damage to the powered mixer.
Please ensure the loadings of your speakers are consistent
with those shown above.