POWERPOD1080/1082 USER’ S MANUAL
PHONIC CORPORATION
INSTANT SETUP
Page 5
INSTANT SETUP
Suppose you have one microphone, an elec-
tronic guitar and an electronic keyboard. Fol-
lowing these instructions to quickly set up your
system:
1. Turn down all LEVEL knobs 19 to the mini-
mal level; position all EQ knobs to the “ 0” ;
turn the MAIN and the MONITOR level con-
trols 31 30 to the minimal level; have +48
Phantom Power off; position all the sliders of
the 7-band EQ at the “ 0” position.
2. Connections:
A) Connect main speaker(s) to the L and R
output located in the rear panel.
B) Connect the microphone to the Lo-Z low
impedance input of channel 1
C) Connect the guitar to the Hi-Z high imped-
ance input of channel 2 and press down
t h e PA D b u t t o n o r c o n n e c t t h e g u i t a r
through a direct box to the Lo-Z low im-
pedance input of channel 2.
D) Connect keyboard to the L-Line-R of chan-
nel 7.
E) Plug the unit
’
s power cord to a power
source.
3. Have the Amplification Mode 34 of PowerPod
1080 or of PowerPod 1082 set at STEREO.
4. Turn on the power. Make sure to turn on
Phantom Power when condenser microphone
is in use.
5. Turn the master level controls of MAIN L/R
clockwise to the 12 o
’
clock position.
6. Turn the LEVEL knob of channel 1, 2 and 7
clockwise to the desired position.
7. Pay attention to the MASTER level meters;
make sure all the +6 LED don
’
t stay lit all the
time.
8. Adjust the 3-band EQ of each input channel
and 7-band EQ to the desired positions.
9. You may turn on the EFFECT adding digital
effect to MAIN L/R output.
