background image

4

Installation instructions 

Roger Dynamic SoundField 

V6.00/20

16-0

2/visu’l/© Phonak AG/All rights reserved/page 4/5

2. Installation 

2.1 Mounting the DigiMaster Floor Stand

Follow the instructions delivered in the DigiMaster Floor Stand  
packaging. 

2.2  Mounting DigiMaster on the wall

1)  Measure 1.40 meters (4 feet) up from floor level and mark this point 

on the wall with a pencil. 
Hold the wall support against the wall so that the pencil mark  
is at the bottom of the wall support. Adjust the wall support using 
the spirit level until it is level. Use the pencil to mark the wall 
through the wall support’s four holes.

2)  Remove the wall support and drill 4 holes using a 5 mm (0.2 inch) 

diameter drill bit. The depth of these holes should be at least  
30 mm (1.2 inches).

3)  Push the anchors into the holes. Mount the wall support using  

the 4 torx screws and the torx T20 screwdriver. 
 

Spirit level

Pencil mark
(1.4m / 4 feet above floor level)

Wall support

30 mm

4)  Mount the array fixation on the DigiMaster by using the two black 

hex screws and hex wrench 5.

5)  Carefully attach the DigiMaster [A] to the wall support and turn it 

to face the center of the class.

6)  Attach the power cable to the power adapter. Plug the power  

cable into the mains and the 19 Volt jack into the socket on the  
bottom of the DigiMaster. Your DigiMaster is now ready to be 
paired with the 

inspiro.

Make sure the power cable is safely positioned!

Please check the Phonak SoundField User Guide to learn about the 
standard functions of Phonak SoundField.

19V

AUDIO

3.2A

19V

AUDIO

3.2A

Reviews: