Chapter 3 Command Descriptions
93
reset snapshot
Description
Deletes the data in a snapshot and resets it to the current data in the associated
master volume. The snapshot's volume characteristics are not changed. The
command prompts you to unmount the snapshot from the host operating system
before performing the reset; leaving it mounted can cause data corruption.
Caution –
All data represented by the snapshot as it exists prior to issuing this
command is lost.
Input
Example
Reset snapshot SS1.
reset snapshot
volume
[prompt yes|no]
Parameter
Description
volume
Specifies the volume by its name or serial number. For the
syntax to use, see “Volume Syntax” on page 25.
prompt yes|no
Optional. Specifies an automatic response to the unmount
prompt that either enables the reset to proceed or prevents the
reset from proceeding:
•
yes
: Enables the reset to proceed
•
no
: Prevents the reset from proceeding
If this parameter is omitted, you must reply to the prompt.
#
reset snapshot SS1
Leaving the snapshot mounted during reset on any operating system
can result in data corruption. Is the snapshot un-mounted from all
operating systems?
yes
Success: Snapshot Reset Complete.
Summary of Contents for RPC12 Series
