226
Phoenix RPC12 Series CLI Reference Manual • September 2008
volumecopy
Description
Copies a snapshot or a master volume to a new standard volume. The command
creates the destination volume you specify, which must be in a vdisk owned by the
same controller as the source volume.
Input
Example
Copy master volume MV1 to new volume RO1 on virtual disk VD2.
volumecopy source-volume
volume1
dest-vdisk
vdisk
[modified-
snapshot yes|no]
volume2
Parameter
Description
source-volume
volume1
Specifies the virtual disks by name or serial number. For
the syntax to use, see “Virtual Disk Syntax” on page 25.
dest-vdisk
vdisk
Specifies the destination virtual disk by name or serial
number. For the syntax to use, see “Virtual Disk Syntax” on
page 25.
modified-snapshot
yes
|
no
Optional. Specifies whether to include or exclude modified
write data from the snapshot in the copy. This parameter
applies only when the source volume is a snapshot; it is
ignored if the source volume is a master volume.
•
yes
: Include modified snapshot data.
•
no
: Exclude modified snapshot data.
If this parameter is omitted for a snapshot, modified
snapshot data is excluded.
volume2
Specifies a name for the volume to create on the destination
vdisk. For the syntax to use, see “Virtual Disk Syntax” on
page 25.
#
volumecopy source-volume MV1 dest-vdisk VD2 RO1
Summary of Contents for RPC12 Series
