N5488100F-4
MS-120V 50-150W HPS Series Installation Instructions
All wiring should be done by licensed electricians in
accordance with state and local codes plus National
Electric Code (NEC) standards. Improper
installation may result in serious injury.
WIRING
Before making any electrical connections, make sure that
power is turned off to the incoming wires.
Loosen ten screws (Item 21) in the removable cover (Item
23). (Cover nearest the 1/2 inch NPSI hole). Remove
barrier (Item 27) for access to wiring compartment.
The wiring compartment now revealed contains a common
wire and a 120 volt lead wire. They are labeled as such.
Connect the appropriate incoming wires to these wires.
Electrical fittings and conductors appropriate for the
application and in compliance with accepted codes must be
used. The green screw inside the compartment is grounded
to the fixture and must be connected to a positive ground.
DON'T CONNECT GREEN (GROUND) WIRE TO POWER
SOURCE.
When wiring is completed, reinstall the barrier, (Item 27).
Reinstall the removable cover (Item 23).
Before cleaning, make sure the fixture is turned off.
CLEANING
When re-lamping, it is recommended that the glass on the
fixture be cleaned to maintain fixture efficiency. This glass
may be cleaned with any non-abrasive conventional glass
cleaner.
The reflector should also be cleaned at this time. Use a soft
cloth with warm, soapy water.
AIMING - HORIZONTAL MOUNTING
Vertical aiming is achieved by loosening the two bolts which
fasten the two mounting harps together. Re-tighten the
bolts when the fixture is in the desired position.
AIMING- VERTICAL MOUNTING
Vertical aiming is accomplished by loosening the two bolts
which fasten the mounting bracket to the fixture. Vertical
travel is about 30
up and 100
down. Re-tighten the bolts
when the fixture is in the desired position.
The angle of the fixture can also be adjusted by loosening
the mounting bolts in the mounting bracket, rotating the
fixture to the desired angle and then re-tightening the bolts.
PHOENIX PRODUCTS COMPANY, INC.
8711 West Port Avenue
!
Milwaukee, WI 53224 U.S.A.
Phone: 414.973.3300
!
FAX: 414.973.3210
www.phoenixproducts.com
CAUTION
CAUTION
