Phoenix GM1-203, Operating Instructions Manual

Page: 6 / 27

5
CONNECTING THE GAS CYLINDER TO THE APPLIANCE
This appliance is only suitable for use with low-pressure butane or propane gas and fitted with
the appropriate low-pressure regulator via a flexible hose. The hose should be secured to the
regulator and the appliance with hose clips or nut. This barbecue is set to operate a 28 mbar
regulator with butane gas and a 37mbar regulator with propane gas and a regulator with
butane/propane mixture at 37mbar and a regulator with butane/propane mixture at 50mbar and
a regulator with butane/propane mixture at 30mbar. Use a suitable regulator certified to BSEN
16129:2013. Please consult your LPG dealer for information regarding a suitable regulator for
the gas cylinder.
BEFORE USE PLEASE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3
parts water.
Ensure the control valve is “OFF”.
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections
are secure then turn ON the gas.
Brush the soapy solution on to the hose and all joints. These include all joints between hose and
regulator as well as hose and barbeque.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also turn the
cylinder
valve off. Wait five minutes before attempting to relight with ignition sequence.
The pan max diameter is 240mm
，
min diameter is 120mm.
Retest after fixing the fault. Turn OFF the gas at the cylinder after testing.
If detected leakage can not be rectified, do not attempt to cure leakage but consult your gas
dealer.
REGULATOR AND HOSE
Use only regulators and hose approved for LPG at the above pressures (See Page 2). The life
expectancy of the regulator is estimated as 10 years. It is recommended that the regulator is
changed within 10 years of the date of manufacture.
The use of the wrong regulator or hose is unsafe; always check that you have the correct items
before operating the barbecue.
The hose used must conform to the relevant standard for the country of use. The length of the
hose must be 1.5 meters (maximum). Worn or damaged hose must be replaced. Ensure that the
hose is not obstructed, kinked, or in contact with any part of the barbecue other than at its
connection.
The hose should not be twisted or kinked when attached to the gas cylinder. No part of the hose
should touch any part of the appliance. So
place
the cylinder out to the left hand side of the
appliance at the maximum distant permitted by the hose length.