A26 INVADER
Instruction Manual
21
3x20mm
Assemble left and right
sides the same way.
2x10mm
2mm
Apply threadlocker
(screw cement).
2 x 10mm Screw
Nut
2mm
2
1
2
Snap keeper
2
1.7x1000mm Push rod
3 x 20mm Cap Screw
2
2
2
INSTALLING THE ELEVATOR PUSHROD
1. Locate the pushrod exit slot on the right side and left
side of the fuselage. It is located slightly ahead and
below the horizontal stabilizer.
2. Carefully cut away the covering material from the
slot.
3. Working from inside the fuselage, slide the threaded
end of the pushrod until it reaches the exit slot.
Carefully reach in with a small screw driver and
guide the pushrod out of the exit slot.
4. Install the clevis into the two elevator pushrod. Make
sure 6mm of thread shows inside the clevis.
5. The control horn should be mounted on the bottom,
left side and right side of the elevator at the leading
edge, in line with the elevator pushrod.
6. Connect the two elevator pushrod using the metal
domino.
7. Locate one nylon servo arm, and using wire cutters,
remove all but one of the arms. Using a 2mm drill
bit, enlarge the third hole out from the center to
accommodate the elevator pushrod wire.
8. Plug the elevator servo into the receiver and center
the servo. Install the servo arm onto the servo. The
servo arm should be perpendicular to the servo
and point toward the middle of the fuselage.
9. Be sure both elevator halves are flat. Center both
elevator halves and hold them in place using a
couple of pieces of masking tape.
10. With the elevator halves and elevator servo
centered, carefully place a mark on the elevator
pushrod wire where it crosses the hole in the servo
arm.
11. Using pliers, carefully make a 90 degree bend up
at the mark made. Cut off the excess wire, leaving
about 8mm beyond the bend.
12. Insert the 90 degree bend up through the hole in
the servo arm, install one nylon snap keeper over
the wire to secure it to the arm. Install the servo
arm retaining screw and remove the masking tape
the elevator halves.
1
1.7x100mm Push rod
1
Domino
