CONTROL UNIT HE-300
Installation
7982
2
(-)
15
6.2.2
Electrical connection
CAUTION
Electric shock
Electrical components should be connected or disconnected only when the power supply cord is
unplugged.
There is a delay after the supply voltage is applied before the device actually turns on. Wait at
least 10 seconds before initial commissioning.
Routing the electrical cables
When routing the cables, be sure that:
•
the cables cannot get jammed,
•
no mechanical load (such as pulling, pushing or bending) will be put on the cables, and
•
the cables cannot be damaged in any way.
Fasten all cables (especially the connecting cables) to the end product using sufficient kink preven-
tion methods. Be sure that the design of the end product prevents the connecting cables from com-
ing into contact with the floor during transport.
6.2.3
Connecting to the POWER SUPPLY HE-300 SMPS
1
Connect the CONTROL UNIT HE-300 to the external DewertOkin POWER SUPPLY, as shown
in Figure 7 . Use the proper DewertOkin cable for this connection.
2
Insert the cable plug until you hear it snap in.
Figure 7
Example: Connecting to the POWER SUPPLY HE-300 SMPS
Summary of Contents for Dewert Okin HE-300 SMPS
Page 2: ......
