CU458-2
Installation
93728 1.0
13
6. Installation
6.1
Safety notices to observe during installation
Basic safety rules must be followed in order to ensure that the end product can be continually op-
erated in a safe manner. These rules must be observed while using the end product and while in-
stalling the CONTROL UNIT in the end product.
6.1.1
Ensuring operational reliability during installation
The safety and reliability of the end product containing DewertOkin components can be ensured by
using the proper construction methods as described below.
6.2
Installation procedure
Before installing and connecting the CONTROL UNIT, make sure that you are observing all of the
safety notices found in the "Safety notices to observe during installation" section.
6.2.1
Mounting the CONTROL UNIT to the end product
Two screws should be used at the two mounting points to attach the CONTROL UNIT to the end
product.
The drilling dimensions shown in Figure 5 only illustrate an example and are not necessarily au-
thoritative for all applications.
Figure 5
Drilling dimensions (example): Mounting points on the CONTROL UNIT (in mm)
Ø 7
158
Summary of Contents for Dewert Okin CU458-2
Page 2: ......
