Type 900HT Series
Electrode Stabilization Ovens
Operating Instructions
Operating Instructions
6
Phoenix International 8711 West Port Avenue Milwaukee, WI 53224 +1 414.973.3400 [email protected]
dryrod.com
N5466104B
02.08.19
Phoenix Ovens International LLC warrants its products against defects in material and workmanship. The company will, at its discretion, repair or replace any properly installed Phoenix International
manufactured product which fails under normal operating conditions within one year from date of receipt. Contact the factory for return authorization before returning the product to Phoenix
International freight prepaid. If our inspection confirms that the product is defective under terms of this warranty, it will be repaired/replaced and returned freight prepaid.
This warranty applies only to products sold by Phoenix International, Inc. and specifically excludes installation or de-installation labor, transportation or equipment of another manufacturer used in
conjunction with Phoenix International products. No other warranty, expressed or implied, exists beyond this warranty declaration.
Phoenix constantly strives to improve its products and therefore reserves the right to change design, materials and specifications without notice.
Warranty
Wiring
Eliminate expensive rework and protect welding profits!
This guide explains proper storage and oven holding temperatures:
• Recondition/rebake procedures for electrode coatings exposed to moisture are included.
• Remove electrodes from cardboard containers before placing in ovens.
• Electrode coatings should not be exposed to the re-baking temperature without first being reconditioned at a lower temperature. Failure to do so may result
in breakdown of electrode coatings. After re-baking, lower temperature to holding level until reissued.
Download your guide at
Guide to Electrode & Flux Stabilization
Note: Two jumpers should be used and placed in both locations
for operation on 240V single phase power. Type 900HT Series
ovens are rated to operate on 240V single phase power.
Variation in voltages within 10% of 240V are acceptable but
modifications should not be made to the unit.
CAUTION
•
All wiring should be done by a licensed electrician in
accordance with state codes, local codes, and National
Electrical Code (NEC) or International Electric Commission
(IEC) standards.
•
Improper installation or use may result in serious injury.
•
Always remove oven from power source before
troubleshooting or repairing.
thermal
couple probe
heating
element
pilot light
white
black
green
Wiring Diagram for
Type 900 Series 240V
conduit
box
variable thermostat
