3
MX 1260
Twelve Channel Bridgeable Amplifier
Using the Controls / Front Panel
Power
The front panel switch will manually switch the MX1260 on or
off. A blue LED behind the logo lens indicates its power status.
Whenever the amplifier’s power switch is in the “ON” position
the front panel lens is illuminated blue.
Using the Controls / Back Panel
Power
The MX1260 can be turned on and off independently via a
switch on the front panel, by signal sensing, or remotely by
a triggered DC input. There is a switch located on the upper
right rear of the amplifier to select how you would like to turn
on the MX1260 . If you would like to control the unit’s power on
/ power off status manually from the front, place the switch in
the “ON” position. If you would like to control the unit’s power
on / power off status by means of signal sensing, place the
switch in the “AUTO” position. If you would like to control the
unit’s power on / power off status by a DC remote trigger, place
If the Amplifier is “Active” while using the Signal Sensed power
or DC Triggered power function the clear ring around the power
switch is illuminated blue. If the amplifier is inactive in these
modes the ring around the power switch is not illuminated.
Congratulations on your purchase of the Innovative Home MX1260. Please take a few moments to read this entire manual,
and be sure to retain this document for future reference. Please read and observe all safety instructions detailed on page two (2).
Note:
If any part of this product is damaged or missing, please call your dealer
or Phoenix Gold Home Products directly at 800-435-7115 or 503-286-9300.
Note:
The front panel power switch must be in the “ON”
position for the 12V triggers or “Auto ON” features to operate.
the switch in the “5-24V” position, and connect the remote
triggering wire and ground from your triggering device to the
terminal labeled “TRIGGER (5-24V)” next to the switch.
You must also connect the ground terminal (GND) to ground for
the trigger circuit to be complete. A third terminal on the same
block is labeled “OUTPUT (DC 12V)”. This allows for remote turn-
on of other devices when the MX1260 is powered on. Please
read the owner’s manual for any devices you are attempting to
connect in this manner to ensure compatibility.
