Phoenix Gold iSeries
www.PHOENIXGOLD.com
8
PC Software
Setting the Gains/
Crossover Point
This screen allows you to set the gain of the
center channel and subwoofer along with the
crossover point of the system. The crossover
point affects both the sub-woofer and the full
range factory speakers.
PLEASE NOTE: The center channel gain is only
valid when the listening position is set to “Off”.
The subwoofer gain is not affected by any
listening position.
To download the iAMP PC Software please visit www.phoenixgold.com/iamppc. Please follow the
instructions included in the download to install the software on your PC.
Once Installed on your PC you can use the software to do the following:
1. Set the 6 EQ user presets
2. Set the gain of the subwoofer
3. Set the low pass filter of the subwoofer
4. Set the gain of the center channel (if present).
5. Set different listening positions (This can also be done from the touchscreen display but has been
added here to allow the user the ability to control it while setting the custom EQ curves).
Connecting the PAC-UP
to the Amplifier/PC
In order to use the PC Software you must first
connect the PAC-UP to the iAMP and your PC
using the supplied cables. The PAC-UP can be
connected either at the 5-pin port on the amplifier
or the 5-pin port located behind the head unit in
the harness with the 44-pin vehicle connectors.
If connecting at the amplifier you may want
to use the supplied USB extension. Once you
are connected to the amp and the PC launch
the iAMP PC software you installed on your
computer.
PLEASE NOTE: The PC interface can only be
used when the amp is installed in the vehicle
with the key on and music playing.
OR
